Cable Traction Belt For Cars And Trucks – Towing Cable For Crane – 4m – 2t – Silver Gray

Advice:
No matter what the level of the car on the road, it will inevitably encounter problems. If the car breaks down on the road and can not move on, as long as the steering or braking system is not in trouble, you can find a car yourself and slide it back before fixing it .
the front end of the tow rope attached before the rear axle steel plate, the other end tied after the following front suspension vehicle as close as possible to the central position, there should be a few meters above the two cars.
it is best to place a tissue in the middle of the rope trailer as an identification mark.
trailers, experienced drivers should drive behind the car, because the car behind the hard to control, and a little negligence or malfunction, it can be pressed on the rope trailer, or bend, an accident occurred.
When the trailer starts, because it is more than the weight of a car, the first has to refuel to increase the speed of the engine, and then slowly relax the clutch pedal so that the rope tightens and starts again.
control the speed of the car, even if the road is very good, do not ride at high speed.
The rope trailer will loosen when the vehicle changes. at this point, the car tow should not interfere with the brakes. otherwise, when the lead car comes on, the rope trailer will suddenly tighten and be hit. only when the rope falls to the ground can you gently press the brakes.
if down ramp is very long, can put the rope down, as the two cars slid down, it is very safe; if the ramp is not long, can hang a rope before the car downhill, easily do not hit the brakes, then the car can touch on the brakes, let the rope still stretched.
in the intersection to stop, the car before the first step on the brakes a little, give the car a signal, and then the car on the brakes, the two cars are stopped. when turning, you must pay attention to the big circle. try to tighten the rope so that there will be no danger.